Back

Base Update Version 3.0.8.1

Screenshot of obstructions and module blocks on a flat roof in K2 Base
Obstructions and module blocks on a flat roof PV system
  • User interface
    • When the user is in the Obstructions tab only obstructions can bee selected in the active roof
    • Roofs can be selected in the Design tab by clicking on any module array
    • Units of measurement is always displayed during user input
    • Added a hint telling the user if a system/fastener etc. is not selectable to change
  • Building codes
    • Germany: Updated wind and snow zones for the federal state Niedersachsen
    • Italy: Added missing postal codes to zone list
  • Pitched roof: SingleRail Climber Set 36/48 has a new article number because of slight design changes
  • Flat roof
    • Dome 6: improved ballast distribution for SpeedPorter
    • Dome Classic with quarter clamping (FlexClamp): Improved load distribution area for mid of a module block
    • Dome Classic and Dome V now also use the Dome 6 Porters (2003150 & 2003151)
    • Changes in the PDF report concering max. pressure under building protection mat: Added LFK 0 in chapter load combinations/serviceability
  • Seam metal roofing
    • Seam type Domitec removed
    • Thermal breaks: Width min. distance & default set to 130mm and the default width is set to maximum
  • Bill of materials: Set article number for placeholder items set to XXXXX
  • Module database: Update filter for import to include wider modules (esp. for pitched roofs)
  • Some bugfixes

We would be happy to receive feedback from you about the new features. Just test it and send uns your ideas for improvement.

 

Back

Go back