S-Dome Small System

    • Suitable on trapezoidal sheet metal for up to 15° roof pitch
    • Economical material and transport
    • Clever in the connection and secure in the holding force
    • Perfect combination of the all-rounder component MultiRail and load-optimised slim elevations
    Dome Classic Properties
    Multifunctional application ­possibilities

    Multifunctional application ­possibilities

    The S-Dome Small system can be installed on flat as well as pitched roofs with a roof pitch of up to 15°. The system is securely fixed with MultiRails and can be equipped with more fixing points depending on wind loads.

     

     

     

    Clamping with FlexClamp Small

    Clamping with FlexClamp Small

    Due to the height-adjustable and universal clamps, different module heights (34-50 mm) can be covered. The high stability of the construction is supported by the clamping on the longitudinal side of the module.

     

     

    Improved rear ventilation

    Improved rear ventilation

    The 10° inclination of the system promotes rear ventilation and creates an improved angle of incidence. Both factors optimise the performance of the PV modules and increase the yield.

    References

    Components

    Downloads

    Product data sheet and brochures

    Document type
    Product data sheet  EN
    Product data sheet  PT
    Brochure Flat roof systems  EN
    Brochure Flat roof systems  PT
    Brochure Pitched roof systems  EN
    Brochure Pitched roof systems  PT

    Assembly instructions and checklists

    Document type
    Assembly manual
    Checklist Trapezoidal sheet metal / sandwich panel  EN
    Checklist Trapezoidal sheet metal / sandwich panel  PT

    Certificates

    Document type
    Certificate static proof

    Technical data

     
    S-Dome Small
    Scope of application

    Flat or pitched roofs ≤ 15° with trapezoidal sheet metal roofing

    Fastening type / roof fixture

    Attached with drilling screws in trapezoidal sheets, parallel to raised crests

    Requirements

    • Sheet thickness: ≥ 0.4 mm steel or ≥ 0.5 mm aluminium
    • Tensile strength for aluminium: 165 N/mm²
    • Tensile strength for steel: acc. to approval min. S235 in acc. with DIN EN 10025-1
    • Crest width: min. 22 mm
    • Crest spacing: independent of crest distance
    Inclination angle

    10°

    Material

    • Mounting rails, Dome SD Small, Dome S1000 Small, FlexClamp Small: Aluminium (EN AW-6063 T66/ EN AW-6082 T6); EPDM
    • Small parts: Stainless steel (1.4301) A2
    S-Dome Small
    Scope of application

    Flat or pitched roofs ≤ 15° with trapezoidal sheet metal roofing

    Fastening type / roof fixture

    Attached with drilling screws in trapezoidal sheets, parallel to raised crests

    Requirements
    • Sheet thickness: ≥ 0.4 mm steel or ≥ 0.5 mm aluminium
    • Tensile strength for aluminium: 165 N/mm²
    • Tensile strength for steel: acc. to approval min. S235 in acc. with DIN EN 10025-1
    • Crest width: min. 22 mm
    • Crest spacing: independent of crest distance
    Inclination angle

    10°

    Material
    • Mounting rails, Dome SD Small, Dome S1000 Small, FlexClamp Small: Aluminium (EN AW-6063 T66/ EN AW-6082 T6); EPDM
    • Small parts: Stainless steel (1.4301) A2

    Side views

    S-Dome Small
    S-Dome Small